ProduktrezensionenDP DP00899 Joggler Panel Flanging and Hole Punch Tool

OK on thin steel only

This was only £14.99. The seam edger will not work on steel above 0.9mm thick, unless you have the strength of Hercules. I had to resort to a pneumatic version as my steel sheet was 1.2mm, but I think it’d be OK on thinner steel if you do not have the luxury of a compressor.Vollständige Rezension lesen...

Bestätigter Kauf:  Ja | Artikelzustand: neu | Verkauft von: forestpark19

very lite duty

the product was as described but was not heavy duty. I could not flange 1.4mm steel on my 56 chevy bel-air. so would be ok on new cars were panels are only 1mm but no thicker than that.

Bestätigter Kauf:  Ja | Artikelzustand: neu | Verkauft von: home-retail-mall

Awfull

A great tool let down by poor engineering . The dies don't close tight enough to crimp the plate in a uniform way. Useless for making over lap panells etc. The punch is ok in thin aluminium .
All in all a let down .Vollständige Rezension lesen...

Bestätigter Kauf:  Ja | Artikelzustand: neu | Verkauft von: dapetz

Nice little tool ! ;-)

Helped me to complete a good job filling in an open air sunroof!

I joggled the car roof so the infill piece sat flush to the car. I used some panel bonding material to stick the roof in place, then used some rivets to mechanically fix in place on my race car. Jobs a good un.Vollständige Rezension lesen...

Bestätigter Kauf:  Ja | Artikelzustand: neu | Verkauft von: dapetz

need to specify item maximum thickness suitably

could only hole a couple of holes , might hole sometimes then would jam, need to be strongman , this was with only 0.8 mm metal. Advert should have specified max thickness item was suitable for. Had to finally use drill for holes for car sillVollständige Rezension lesen...

Bestätigter Kauf:  Ja | Artikelzustand: neu | Verkauft von: dapetz

more basic then i should have bought

worked as required

Bestätigter Kauf:  Ja | Artikelzustand: neu | Verkauft von: dapetz

Low quality tool

I used it 5 times and it broke. The thread of parts broke when I made pressure to bend a car metal panel. The damaged part just destroyed itself.

Bestätigter Kauf:  Ja | Artikelzustand: neu | Verkauft von: dapetz

value for money.

good value for money.for the price,good quality.

Bestätigter Kauf:  Ja | Artikelzustand: neu | Verkauft von: home-retail-mall

joddler

could not get this to work on 1.5 mm steel

Bestätigter Kauf:  Ja | Artikelzustand: neu | Verkauft von: pjsdiscounts11

Not a bad tool

Dos the I want it to do