5Sterne
0Bewertung4Sterne
0Bewertung3Sterne
1Bewertung2Sterne
0Bewertung1Stern
0Bewertung
Would recommend100% stimmen zu
Good value100% stimmen zu
Good quality100% stimmen zu
1 Rezension
LOOKS LIKE IT SHOULD WORK, BUT A LOT OF WORK TO MAKE IT FIT!
1. The shroud was too wide top to bottom, requiring bending the top and bottom shroud lips by about 30 degrees to make it fit. (I used a 10" adjustable wrench set to the sheet metal thickness to do this-- very laborious.)
2. The side support panel lips had to be cut down by half to enable the mounting brackets and the radiator to fit flush to the mounting surface-- had to be very carefully done to avoid damaging the core.
3. The upper right side support had to be cut partially away at the upper rear to make room for the oil separator tubing. Again, a tricky process to avoid damaging the core.
4. The mounting flange holes had to be lengthened to fit mounting holes.
5. The drain "plug" was unacceptable-- I had to purchase a proper 1/4" drain valve. Should have been included.
6. In order for the 2 fans to run simultaneously, the 2 thermosensors have to be wired in parallel.
7. After all this, the radiator operates satisfactorily so far, but only hot weather will truly tell the story.Vollständige Rezension lesen...
Bestätigter Kauf: Ja | Artikelzustand: neu | Verkauft von: just-intercoolers