5Sterne
9Bewertungen4Sterne
0Bewertung3Sterne
0Bewertung2Sterne
0Bewertung1Stern
0Bewertung
Would recommend100% stimmen zu
Good value100% stimmen zu
Good quality100% stimmen zu
8 Rezensionen
Excellent for vcarving. Very clean cuts
Sharp bits! I love the clean cuts I get that don't need any sanding afterwards. Highly recommended for small v-bit carving.
I was also sent free of charge a very nice Kyocera 1/8" carrying case and I immediately put all of my 1/8th inch bits into it Vollständige Rezension lesen...
Bestätigter Kauf: Ja | Artikelzustand: neu | Verkauft von: drillman1
Great bits!
These are great bits that put in work. Use them everyday and haven't had a problem with them. Extremely sharp so be careful when installing them in your collets.
Excellent value!!
Bestätigter Kauf: Ja | Artikelzustand: neu | Verkauft von: drillman1
When oredering 10 pcs, 37 euros were added by Belgium customs
Use: PCB track Isolation. It works perfect and clean with a single pass at 60.000rpm and 3mm/s speed.
Bestätigter Kauf: Ja | Artikelzustand: neu | Verkauft von: drillman1
Using on aluminum .040 deep and looking great
Was very impressed for the job I using them for
Bestätigter Kauf: Ja | Artikelzustand: neu | Verkauft von: drillman1
Nice for fine detail lettering
These work great for fine lettering as long as your feeds and speeds are on the money thank you.
Bestätigter Kauf: Ja | Artikelzustand: neu | Verkauft von: drillman1
Good value.
Works well and lasts well, great value.
Bestätigter Kauf: Ja | Artikelzustand: neu | Verkauft von: drillman1
performance as expected
I have not bought a Kyocera tool that disapointed in value or performance
Bestätigter Kauf: Ja | Artikelzustand: neu | Verkauft von: drillman1
Nice bit
Very sharp and lasts a long time
Bestätigter Kauf: Ja | Artikelzustand: neu | Verkauft von: drillman1