13-pin In-Line Male Din Connector - Philmore ETA13

Very difficult to solder to the pins- plastic body melts.

The pins on the connector are very difficult to solder, not only due to their close spacing, but when any heat is applied to a pin the plastic body of the plug softens and melts. There must be a better way to connect wires to these pins. A connector with a few inches of wire connected to each pin would be much more useful.Vollständige Rezension lesen

Bestätigter Kauf:  Ja • Artikelzustand: neu • Verkauft von: cqradiosupply