A high quality product, where the hands slip into and out of very easily, while wearing gloves. Riding in close to 0 deg centigrade with summer gloves is a treat, and installing or removing takes about 30 seconds. All in all, a great product, with plenty of reflective piping for night time safety. For me, the added safety of riding with non-bulky thick gloves, provides for accurate braking and throttle control.
Bestätigter Kauf: Ja | Artikelzustand: Neu
Bought these as I had a similar pair on my vespa a few years ago.... I thought I would chance it and buy these for bike packing on my fat bike... I can say after 3 rides in the Scottish Highlands these are great! They look big and clumsy but they give you confidence for getting your hands in/out to signal and if you need to get your hands out quickly in case of an accident..... The quality is good, sturdy, waterproof and well made.. The logos and piping is reflective and bright, great for urban riding too... Easy to fit on/off... Al round Great!!
Bestätigter Kauf: Ja | Artikelzustand: Neu
Having bought the oxford handle bar muffs I was waiting on them as I had a pair in the 80s on my bike then having receive then new update ones My 1st thought was .there big .and I mean big So I went and put them in the bike . My winter hack. The trusty Honda cb125f .they were not only looked big but once on the bike they looked like some ground aids on a F1 race car. I did a 34 miles run where I had to take them off as I felt them to be dangerous. Not only that they didn't do much protection even with my gloves on inside. Also disappoint to see there no longer made in the uk Start rateing 0
Bestätigter Kauf: Ja | Artikelzustand: Neu
easy to fit glove muff covers hands wrists .wore it for two hours at 7c with hand grips on low no more cold fingers ,hands slip in and out easy when adjusting visor etc , january uk
Bestätigter Kauf: Ja | Artikelzustand: Neu
Good product which overall does as it should in keeping gloves dry and hands warmer during cold, wet riding. Both mitts have an aperture for the Brake master cylinder reservoir. This is great on the RH one, but leaves an opening on the LH one. Some means of covering this would be ideal to prevent ingress of water. I have taped over it.
Bestätigter Kauf: Ja | Artikelzustand: Neu
Aktuelle Folie {CURRENT_SLIDE} von {TOTAL_SLIDES}- Meistverkauft in Hand- & Lenkstangenprotektoren