 |
Small, compact, a bit fiddly but if fitted with care, work well. The solenoid inside is very small and can easily be restricted in movement if not carefully positioned aligned with the point/turnout tie bar. If screwed down too hard to the base board this can also restrict movement. Follow Horny's instructions and you'll be OK.
Bestätigter Kauf: Ja | Artikelzustand: Neu
This is a good basic point motor with little hassle to fit to your layout, my only criticism is that it will really only fit on Hornby points, if using Bachman or Peco points the small lever will not fit onto the tie bar, so either you have to change the point (expensive) or fit a Peco point motor, (nearly as expensive).
Bestätigter Kauf: Ja | Artikelzustand: Neu
It's OK; It's neither good or bad, neither good or bad value and of slightly flimsy quality. There are only 3 wires, one common (black), so one cannot wire a basic capacitor discharge unit such as those I made. Hornby expect you to use their tacky passing contact switches. The unit can be opened up and rewired, i've found, but it's a tricky job and needs delicacy.
Bestätigter Kauf: Ja | Artikelzustand: Neu
I have purchased a number of these over the past 12 months and had a problem with only one which seemed to stick so was in danger of burning out. otherwise seem pretty reliable but require careful operation of the throw switch. Caution do not leave control throw switch in a central position as this particular model of point will burn out in a matter of seconds
Bestätigter Kauf: Ja | Artikelzustand: Neu
No fiddling about or leaning across the layout,just push the button of the point you want. Easy as that its great,I think there super.
Bestätigter Kauf: Ja | Artikelzustand: Neu
Aktuelle Folie {CURRENT_SLIDE} von {TOTAL_SLIDES}- Meistverkauft in Gleismaterial
Aktuelle Folie {CURRENT_SLIDE} von {TOTAL_SLIDES}- Hier sparen: Gleismaterial
Aktuelle Folie {CURRENT_SLIDE} von {TOTAL_SLIDES}- Auch interessant
