I am a professional home improvement contractor. This is an O.E., brand new kit that is essential for anyone with the appropriate pneumatic nail gun that has stopped shooting nails due to internal air leaks at the top of the gun or at the trigger. The kit comes complete with everything you need including seals/gasket, other typical wear parts, grease and tools (wrench and pick). I give this product 5 stars with one reservation. The directions are generic and this kit is applicable to 3 different models of nail guns and each have subtle differences. My specific problem is with the directions for replacing the trigger valve. It states you need to remove a roll pin but neglected to mention a second pin which depending upon which side of the gun you are looking at, the second pin is hidden behind a sticker which addresses the multiple trigger settings. So just know that if you are rebuilding a FC350A framing nail gun, there are (2) roll pins securing the trigger valve. Perfect fit and fix that saves money over replacing a tool worth saving. I highly recommend this kit. Vollständige Rezension lesen
Bestätigter Kauf: Ja | Artikelzustand: Neu
Awesome kit, and good quality o-rings. I did buy the Porter Cable branded kit, and it was worth every cent. It arrived in just a few days, well packaged so nothing delicate would get broken as there are some plastic parts you have to replace. Put your glasses on because there is one tiny o-ring that fits in the trigger pull and you could easily miss it or drop it, or think it didn't come in the kit. In the trigger pull you have to drive out two snap rings, which is not hard, you just have to be careful. When you open the kit you'll think they sent to many things, but you need it all. Good luck and shoot some nails.
Bestätigter Kauf: Ja | Artikelzustand: Neu
I used this kit to rebuild my Porter Cable FR350A framing nailer. Al of the parts included are perfect size and exact replacements for all of the internal parts. Instructions are very good and it took longer for me to disassemble and CLEAN all of the old deteriorated and crumbled bits and pieces out of the nailer. I encountered only ONE PROBLEM with the instructions. The instructions show that the trigger activator is held in by only one roll pin which must be driven out to remove the part. I found that my FR350A had two roll pins and one was covered by a small sticker that showed changing operation of the trigger from single fire to bump-fire. It added extra time for me to figure out why the trigger activator would not come out of my nailer after removing the roll pin indicated by the instructions. Once the second roll pin was driven out, everything proceeded well. Overall I am pleased with the quality of the kit and would purchase it again. It restored my inoperative nailer to like new performance in less than one hour. If you don't encounter the "hidden" roll pin like me you should be able to complete the job in about 30-40 minutes.Vollständige Rezension lesen
Bestätigter Kauf: Ja | Artikelzustand: Neu
It came with all the parts needed to rebuild my nail gun, all parts fit exactly as described. Directions could use a little more details, but just make note of how you take it apart and you'll be fine putting it back together.
Bestätigter Kauf: Ja | Artikelzustand: Neu
I ordered the kit to repair my many years old but lightly used nail gun. The kit is very high quality with very good instructions and a exploded view of all the parts and how they fit in the tool. I now have a very high quality Porter-Cable tool that is working again thanks to the repair and rebuild kit.
Bestätigter Kauf: Ja | Artikelzustand: Neu