Info
Alle Bewertungen (114)
- argentogatto (13769)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufA+ Thank you for being a member of the eBay Community!
- hbarsci (17254)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufGood buyer, prompt payment, valued customer, highly recommended.
Rezensionen (3)
08. Sep 2021
Does not match oem size., not useable.
My R0618 brake bands are marked as produced in 2015 because I have had them on the shelf for a couple years.
The steel backing band is between 1/4 and 1/2inch too short for my 1968 Farmall 140 drums so the freshly lined bands will not slip slip fit. They can be wedged on with some chamfering and heavy persuasion but then it will be like driving with the parking brake on and they will not actuate quite right. I would not buy these again even at the price I paid which was about 1/4 of the present going rate.
12. Jun 2021
Economical and Big
Will work with common coffee filters or the larger restaurant size if you just need rough filtering, no cutting needed. The perforated portion is 90mm diameter, 110mm filter disks will give a good seal.
This is a large funnel all around, be sure to check the diameter of the opening in your glassware. The stem is about 23.5mm at the small end, 31mm at the big end and 80mm long; it seems to be the same taper as ground glass joints and 29/xx works well. The tip will fit into a 24/xx joint but you will have liquid running down the inside of the glass which could get into the vacuum port on many typical setups.(In a pinch it would work fine on a two neck 24/xx boiling flask though.)
02. Jul 2018
Poor fit, too big.
It is a poor fit, the correct part number ordered and sent I triple checked, 2286st for a Yamaha XT-350 year 2000. at least 1/2 inch too long and 3/8 inch too wide, which makes it bunch up and bulge and installing is a bit difficult. The stock filter sits flat and slides in without fuss. i can't return this as I commute with this bike so I need a filter and the old [oem] filter was so old it started to tear in the last removal.
The length could be trimmed along the open edge but of course it won't be a nice factory edge when your done, the width however is a real issue as trimming would separate the halves. The material seems to be good quality, time will tell.