Info
Alle Bewertungen (2.049)
- hjt-9723 (1507)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufGood buyer, prompt payment, valued customer, highly recommended.
- dvspowertools (73266)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufGREAT BUYER WHO MADE IMMEDIATE PAYMENT!HOPE YOU VISIT AGAIN SOON.DVS POWER TOOLS
- *****- Bewertung vom Käufer.Letzter MonatBestätigter KaufGood buyer, prompt payment, valued customer, highly recommended.
- richardboston2009 (3108)- Bewertung vom Käufer.Letzter MonatBestätigter KaufThanks for buying. Your order is on its way 👍
- tech-store-uk (3132)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufGood buyer, quick payment, highly recommended. Thanks
- stevenn56 (12092)- Bewertung vom Käufer.Letzte 6 MonateBestätigter KaufQuick response and fast payment. Perfect! THANKS!!
Rezensionen (3)
11. Mai 2021
OMG... How much??
Cured my 2.4 D5 of chattering engine noise (from EGR valve?) / poor brake servo action / poor pickup. Relatively easy to fit too.
Clearly made from pure Unobtanium though...... Make sure you're sitting down before you look at the price (but to be fair it appears to be the same price everywhere)
Whilst you're fitting it, put some lube on your gear selector rods, you'll be glad you did 🙂
06. Feb 2018
Perfect for an HP Gen8 Microserver....
.....but do make sure you uprate the cooling !
19. Mai 2019
Meh.... It works, but not for long.
1 von 1 finden das hilfreich Instructions are rubbish. Best way to figure it out is to watch some videos on YouTube - search for "Gen2 bearing".
Relatively cheap compared to the ones from the likes of Laser tools, but obviously built down to a price. This kit *just* managed to remove and install the front wheel bearings on my V60, but suffered from the thrust bearing on the main puller rod collapsing (twice)
Worse, the four force transfer pins actually started to bend as such a high force is needed to get the pressing bearings to start moving. Once these bend it is game over. In the end I pressed (no pun intended) 4 x M12 high tensile cap head bolts into service as a replacement. These were an absolute pig to hold in place whilst assembling the tool on the hub - a friendly Octopus would have helped LOL - but they coped much better with the forces involved.
In summary, this just about does the job for two bearings on one vehicle but be prepared for a struggle and you might like to have some spare 51106 type thrust bearings handy. It's OK for a competent DIY'er but completely unsuitable for continued use, by a independant garage for example.