Info
Alle Bewertungen (985)
- messtechnikhandel-gmbh (13517)- Bewertung vom Käufer.Letzte 6 MonateBestätigter Kauf20 Sterne von mir * spewa.de sagt vielen Dank !!!! Gerne wieder mal
- voelkner_de (202920)- Bewertung vom Käufer.Letzte 6 MonateBestätigter KaufDanke für die angenehme/problemlose Transaktion. Ausgezeichneter Käufer. Note 1
- elektriese_eu (174368)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufReibungslose Kommunikation. Sehr angenehmer Geschäftspartner.
- schrauben-auktionen (35709)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufAlles bestens ***** a-f-acero2014 ***** sagt DANKE Besuchen Sie uns wieder..
- switch_elec (779573)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufBin gerne zu weiteren Geschäften bereit. Danke.
- celiqastore (2840)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufSeriöser Käufer, prompte Bezahlung, geschätzter Kunde, vorbehaltlos zu empfehlen
Rezensionen (12)

14. Okt 2016
Macht, was es soll ...
Erworben habe ich die Probes zur Messung von Batteriespannungen. Dank dr scharfen Spitzen werden die Messergebnisse noch genauer, weil damit etwaige Vermutzungen der Batteriepole durchdrungen werden.

19. Mai 2017
Quality with restriction ...
Past week I destroyed a USB-Connector by connect a cable, the connector isn't made to change often the cable. But this is not a problem of the Connector, the problem comes from manufacturing. Because the Connector is soldered same like a voltage regulator on board. To connect a cable to the connector often the physical pressure is much higher than the pressure to any other part of the board. So you have the possibility to give the Connector extra solder. In this, you may find out, that the Connector is very head sensible, so sensible, that you couldn't use the connector after extra solder any more.
I have to part my rating for this product in two parts,
1. the USB-Connector: OK, if you don't change often the Cable and you are very carefully to connect them;
2. The Board itself: Absolutely perfect, it charge the Battery carefully (a bit slowly, but it doesn't happens). On charging, you have a red LED on the Board, after ready charging, you see a blue LED. If the voltage of battery reach 4.2 volts, charging stop automatically. Second Connection on the board you may solder a cable to the load, if the capacity of battery is getting to low, the board stops the current flow, no manually monitoring needed. Stop charging and stop current flow makes the board save and effective. Last but not least you could solder a Cable to charge with 5 Volts.
All in all, I like the product.

24. Mär 2018
Ausgezeichnet !!!
Habe die Pumpe zum automatisierten Giesen meiner Pflanzen gekauft. Diese in den Wasserkanister eingelassen und kann getrost verreisen, weil richtig dosiert, einkleiner Microcontroller für mich das Giesen übernimmt.
Im Gegensatz zu vielem Zeuch, das auf dem Markt herumschwirrt und sich Pumpe nennt, macht diese, was sie soll. Daher +++