Info
Alle Bewertungen (326)
- galaxystar-1308 (768)- Bewertung vom Käufer.Letzte 6 MonateBestätigter KaufGood buyer, prompt payment, valued customer, highly recommended.
- *****- Bewertung vom Käufer.Letztes JahrBestätigter KaufThank you for your payement and patience. Please dont hesitate to reach out if there are any issues.
- allstateus (915127)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufThanks for buying a SquareTrade warranty. Call 877-WARRANTY if you need help!
- matryoshka1 (23471)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufQuick response and fast payment. Perfect! THANKS!!
- itsallwavybaby (1090)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufU R Da Bestest Buyer Ever. Thanks For Being You! :)
- gsharpmusic (10886)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufHope to deal with you again. Thank you.
Rezensionen (4)
20. Jul 2016
Bunch of pens
Lots of pens here. A few were junk but I guess that is expected. From the photo, I did not expect over half to be pens with predominate red decoration but not red ink. Overall, if you want to have a lot of pens laying around, this is a good value.
22. Mär 2017
Make sure your tub surround is perfectly flat
Make sure your tub surround is perfectly flat and has no curvature at all. This splash guard is solid plastic and will not bend to fit any curvature at all. One side installed "okay". Its not perfect but I can live with it. You get one shot at doing this install. The adhesive that holds the guard to the wall is VERY sticky. It will stick solid to whatever it touches. You should probably have two people do the install: one to line up the bottom and one to line up the top. There are no install instructions.
When I went to put the guard on the other side of my surround, I thought I was a lot smarter. I took the removable bottom off the guard and put that down first. Then I would insert the top part into the bottom and rock the piece from the bottom to the top to fit it to the wall. Apparently my surround, although brand new in a new house, has a slight curve to it. The shield has a 1/4" gap from the wall to almost to the top of the guard. I pushed as hard as I could to get that guard to seat against the wall. It is impossible. Since there was no seal for most of the length and it was only stuck at the top, I was able to pry it off with a putty knife. Now I have to figure out how to get the glue off my surround without damaging it.
I would advise getting a long level and put it against the surround where you plan to install this guard. If you see any gaps, you will have these same gaps when you install the guards.
27. Okt 2016
Good value
1 von 1 finden das hilfreich If you want an easier way to make your own network cables, use these connectors. I'd say 100% easier and well worth the price.