Info
Alle Bewertungen (161)
- gbws-shoulou (1679)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufGreat communication. A pleasure to do business with.
- kayfast1 (1499224)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufPerfect! A++++++++++++++ highly recommended by Kay's Fasteners
- hkdz-2021 (13995)- Bewertung vom Käufer.Letzte 6 MonateBestätigter KaufGood Buyer. Patient and gentlemen. Fast payment .A
- tradediydirect (76018)- Bewertung vom Käufer.Letzte 6 MonateBestätigter KaufThank you for an easy, pleasant transaction. Excellent buyer. A+++. MJ Sealants
- tentsparesltd (39570)- Bewertung vom Käufer.Letztes JahrBestätigter KaufGood buyer, prompt payment, valued customer, highly recommended.
- customweldmesh (5435)- Bewertung vom Käufer.Letztes JahrBestätigter KaufGood buyer, prompt payment, highly recommended! *CustomWeldMesh*
Rezensionen (4)

07. Feb 2019
Easily fitted.
If your Corsa boot stops opening, this is the likely solution. The boot can be released for repair by pushing a ribbed plastic lever on the side of the catch, from inside the car. To diagnose, remove the 2 pin connector and short the pins on the harness together. (Measuring voltages is a bit puzzling). Comes with grey primer cover, pop it off carefully with a screwdriver and snap on the old one from your own car. Alternatively, don't remove the old handle from the boot - just swap over the microswitch, which is moulded onto the back of the connector. It can be removed easily enough on its own.

02. Jun 2021
Flimsy and will rust.
Flimsy, one coat of paint on steel so will soon rust at the seams. Not well packed so dented at one corner. Lid dies not lift properly because it pivots at the wrong point.
I will try to overcome these flaws with DIY mods but I am not hopeful it can be used at all.
Size is good!

02. Jun 2017
Good Value
Good value for a proper meter which gives reliable readings.
It is possible to pull the lead out of the probe shroud, so I recommend squeezing a drop of glue around the lead where it enters the shroud.
To connect your own leads to this meter you need 3.5mm diameter banana plugs, which take some time to find on ebay.