Info
Alle Bewertungen (494)
- easylife1983 (30205)- Bewertung vom Käufer.Letzte 6 MonateBestätigter KaufThank you for an easy, pleasant transaction. Excellent buyer.!!A++++++++++
- buyeasyshop2017 (18765)- Bewertung vom Käufer.Letzte 6 MonateBestätigter KaufHope to deal with you again. Thank you.
- taggedv (10024)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufQuick response and fast payment. Perfect! THANKS!!
- *****- Bewertung vom Käufer.Letztes JahrBestätigter KaufQuick response and fast payment. Perfect! THANKS!!
- ebeauty365 (204398)- Bewertung vom Käufer.Letztes JahrBestätigter KaufGreat communication. A pleasure to do business with.
- queerback01 (773)- Bewertung vom Käufer.Letztes JahrBestätigter KaufThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
Rezensionen (6)
31. Jan 2018
Can also be used for windlass or bow thruster controls on a boat.
A great and inexpensive system that has been used on boats for controlling an electric windlass, electric winches and an electrically driven bow thruster. Usually radio control devices for these systems on a boat cost a lot of of money, often well over £100 each. But this little device is well up to doing the job.
Highly recommended.
26. Jun 2018
Putting the adhesive cartridge and two part mixing gun together ready for use.
It’s easy and straightforward when you know, but I didn’t, so I had a look on “You Tube” and saw a short video describing how the parts are put together, then I was ready to go.
The dispensing gun gives more time to apply the adhesive and get the two parts stuck together. The adhesive I’m using has a short working life from mix to use such that every second counts. Using the dispenser where I have several parts to join together give me time to dispense and join the first two parts, put them in place then dispense adhesive to the next set of parts before it goes off in the mixing tube and so on, but in my case I need to be quick and this system allows me to do just that.
It’s brilliant, I couldn’t have done the job without it.
03. Jul 2018
e-teck mixer tubes
These tubes used in conjunction with an adhesive dispenser allowed a two part adhesive with a limited working time to be dispensed correctly mixed to several small parts one at a time in turn where each part was put into place before applying adhesive to the next part. It meant working quickly with little or no time between placing each component, but having carefully prepared each part in readiness, all were put into place with the minimum of wastage of adhesive and the most economical use of mixer tubes. Once used the mixer tubes were then discarded where they remained full of adhesive, but because the tubes were of a slim design, there was only minimal wastage of adhesive. The mix within each tube was thorough and after allowing time for curing, each of the smaller components were found to be very securely attached to the main component.