Info
Alle Bewertungen (66)
- the_it_surplus_store (6265)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufThanks for speedy payment
- casuntek (172908)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufGreat communication. A pleasure to do business with.
- efil.collection (167)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
- galactictoysllc (134658)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufGreat communication. A pleasure to do business with.
- jpmodelkit (310)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufGood buyer AAA+++ , Thank you!
- *****- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufThanks for your purchase - hope to deal with you again - stay safe
Rezensionen (1)
12. Dez 2019
Skip it. Get an official one.
1 von 1 finden das hilfreich Very poor quality Ender 3 clone.
The heated base is a 100x100mm aluminium plate stuck by kapton tape to a 235x235x4mm plain aluminium plate. Do not expect to reach temperature at the edges, it doesn't even come close.
The machine gives the impression of being quite quiet, however this is just due to the fact that the PSU is horrifically underpowered. I replaced the aforementioned hotbed with an official Ender plate, and it couldn't hit above 50 degrees.
Replace the PSU and you get the signature Ender 3 noise as the fans finally reach the expected speed. Again, the Ender 3 isn't a quiet machine, however this clone cheaps out even on those, and so if you do want to be in the same room, you'll need to replace those too.
My hot end blew up within a week of use, however I can't be certain if that was user error or not.
Honestly though, give this a skip. Between the cost of this machine, and what I've had to spend getting mine to a reasonable state, I'd have been better off just getting an actual Ender 3. That's not including the time I've sunk in to it.