sat9144h auf eBay

Info

Standort: USAAngemeldet seit: 11. Jul 2013

Bewertungen

Letzte 12 Monate

Positiv16- positive Bewertungen der letzten 12 Monate

Neutral0- neutrale Bewertungen der letzten 12 Monate

Negativ0- negative Bewertungen der letzten 12 Monate

Alle Bewertungen (90)

thepartsdepartment (175543)- Bewertung vom Käufer.
Vor über einem Jahr
Bestätigter Kauf
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
*****- Bewertung vom Käufer.
Vor über einem Jahr
Bestätigter Kauf
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
sneakercycle (83621)- Bewertung vom Käufer.
Vor über einem Jahr
Bestätigter Kauf
SneakerCycle thanks you! Quick response and fast payment. Perfect!
dadams9799 (3026)- Bewertung vom Käufer.
Letzte 6 Monate
Bestätigter Kauf
A+++
jcs_computer_store (56889)- Bewertung vom Käufer.
Letzte 6 Monate
Bestätigter Kauf
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
*****- Bewertung vom Käufer.
Letzte 6 Monate
Bestätigter Kauf
Hope to deal with you again. Thank you.

Alle Bewertungen ansehen

Rezensionen (14)

Broan/Nutone Replacement Charcoal Range Hood Filter 41F, 97007696 - NEW

26. Jan 2023

Broan/Nutone P/N 41F Charcoal Range Hood Filter

OEM filter fits perfectly as expected

1 von 1 finden das hilfreich

NuTone Bathroom Exhaust Fan Ceiling Clean Cover Roomside Series 110 CFM Air Vent

06. Aug 2022

Great value at near new condition.

This was sold as an open box, new Nutone bathroom exhaust fan. It installed and worked properly, but was missing a hardware kit to secure the power cord. Since this product was sold at about a 50% discount from new, unopened condition. I was able to work around this small problem.

Carburetor Air Filter Fits Poulan 1950 2050 2150 2375 Walbro WT-89 WT-324 WT-391

14. Feb 2018

Carburetor kit for a Poulan 2050 chainsaw.

This kit is a great value, but there were several fit issues with my Poulan chainsaw. 1. The outer diameter of the fuel and primer lines is too large to fit through the existing holes in the fuel tank. I had to slightly increase the diameter of these holes with a drill bit. 2. The supplied carburetor is mechanically different from the original Walbro carb. The choke linkage is larger and more complicated and interferes with the air filter box. I had to cut a hole in the plastic air filter box to allow full motion of the choke linkage. 3. The primer port is on the right hand side of the original carb and is not bent. On the replacement carb it is on the left hand side and is bent downward at a 45 degree angle. I had to carefully bend it to a straight position and re-route the primer line to attach to it. This was necessary to prevent interference with the throttle linkage. 4. After making these modifications, the saw started up immediately.

1 von 1 finden das hilfreich

Alle Rezensionen ansehen