Info
Alle Bewertungen (19)
- tronicsstores (69)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
- topservicestore1992 (15976)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufHope to deal with you again. Thank you.
- oemparts2 (6793)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufGood buyer, prompt payment, valued customer, highly recommended.
- tonewmarket_9 (2278)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
- allstateus (915118)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufThanks for buying a SquareTrade warranty. Call 877-WARRANTY if you need help!
- nQST2j3-SzS@Deleted- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufGREAT COMMUNICATION. A PLEASURE TO DO BUSINESS WITH. AAA+++
Rezensionen (2)
29. Jun 2018
Perfect fit
This was for a review for a shaftseal PS 3867/viton PS-200.It was my fault that I accidentally damaged the original shaft seal on my pool pump by running it dry. Found this online and ordered it when it arrived I was back up and running in less than an hour. Product is better than the original as it is more resistant to salt water. Perfect fit easy maintenance for a DIY. I am pretty technically inclined however.
29. Jun 2018
Applied to my '05 Dodge 3500
I did some exhaust system work on my Dodge 3500 2005 the hangers to quite it right after I was done and I found that I need a slightly longer hanger than the existing one was. Found this online. Once it arrived I installed it in about 30 minutes probably could have done quicker but I'm a learner and I do it yourselfer who likes to take his time and do it right the way I want it. The best way I found to put this on was to get a very large set of channel locks. Place The Grommet up by the hanging brackets and then put the channel locks on both sides (in other words: one side of the pliers squeeze is the grommet side. The other side of the channel locks squeezes on to the Hangar where it turns and vertically goes up to attach to the truck) and squeeze it onto the hangers it was a little tight for my hangers which is good. I actually put the old shorter hanger grommet back over and hanging pins to keep this grounded as far on to the hanger as possible. I'll try to attach a picture.