mysons88 auf eBay

Info

Standort: USAAngemeldet seit: 21. Mai 2003

Bewertungen

Letzte 12 Monate

Positiv0- positive Bewertungen der letzten 12 Monate

Neutral0- neutrale Bewertungen der letzten 12 Monate

Negativ0- negative Bewertungen der letzten 12 Monate

Alle Bewertungen (1.269)

c***. (190)- Bewertung vom Käufer.
Vor über einem Jahr
Bestätigter Kauf
Received as advertised; packaged very well; satisfied with purchase.
1***7 (105)- Bewertung vom Käufer.
Vor über einem Jahr
Bestätigter Kauf
The item I ordered is exactly as discribed, arrived ahead of schedule
h***e (208)- Bewertung vom Käufer.
Vor über einem Jahr
Bestätigter Kauf
just like he said, arrived on time, thanks so much
o***o (2289)- Bewertung vom Käufer.
Vor über einem Jahr
Bestätigter Kauf
Fast shipping and good deal. Thanks.
l***l (1664)- Bewertung vom Käufer.
Vor über einem Jahr
Bestätigter Kauf
Product was as advertised A+
-***i (1725)- Bewertung vom Käufer.
Vor über einem Jahr
Bestätigter Kauf
Item as described.

Alle Bewertungen ansehen

Rezensionen (4)

Foot Operated Air Pump For Ball Bike Bicycle Tire Inflator Inflatable Mattress

16. Mär 2016

Good value manual air pump

Everything worked as listed. The only issue was the nozzle which hooks up to the tire vale was a bit tight so when you released the nozzle it was slow in coming off so some of the air leaked out. A little oil and pumping a few extra pumps before diconnecting the nozzle solved the problem.

rc power supply 575watts 47amps icharger turnigy chargers,get 2 run in series!

02. Aug 2017

Output wires for bullet connector.

A good power source for RC chargers requiring high amps. If you plan to constantly draw 40 amps or use mutiple high output chargers be sure you use at least 12 gauge wiring anything smaller and the wire can get hot. I am running 3 high out put chargers and use 10 gauge wire from the power supply to the three way spliter after that I use 12 gauge wire to the chargers. Fan is constantly on which I like because I charge large 6S lipos and I've seen a few thermostat failures which can cause the power supply to burn up.

1 von 1 finden das hilfreich

Permanent Glass Ionomer Dental Cement Crown Bridge Veneer Cure Luting Adhesive

21. Mai 2016

Instuctions for use needs some updating

Mixing instructions are good. Application of cement to the crown and base of the tooth needs to dry. User needs to have something to bite down on to force the crown in place (a small paper towel rolled up to about the size of a cigarette), wait a few minutes for cement to set. Finally gently use a floss and pick to clean out excess cement. .

9 von 9 finden das hilfreich

Alle Rezensionen ansehen