Info
Alle Bewertungen (94)
- dp4store (32228)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufQuick response and fast payment. Perfect! THANKS!!!
- roboc7 (33742)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufA░W░E░S░O░M░E░ ♪♫♪ ░B░U░Y░E░R░ "Food Magic Seal" Thank you
- liyuan1122- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufGood buyer, prompt payment, valued customer, highly recommended.
- kzred-1 (1845)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
- parts_via (327111)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufThanks!! Great buyer, fast payment! A++++
- keycoinc2006 (72545)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
Rezensionen (2)
11. Nov 2019
Works fine in a 1992 TRX300FW
Ordered this aftermarket starter for my 92 TRX300FW and it arrived quickly. My original starter began working again so I figured I would wait until it acted up. Fast forward a few months and it was time to change it. Not hard to do and it fits and functions just fine. There are some web forums stating these are noisy. Mine sounds just like the original equipment and I have about 20 start/stops on it so far. Good value for the money.
I would do something different next time. The gear reduction cover has a small bearing that the starter shaft rides in. Mine is a little rough and I wish I had one to install when I had the cover off. I plan to change that after hunting season.
31. Aug 2019
Didn't go well
Rather than a box of parts, I received a soft sided mailer envelop with everything loosely inside.....hmmm. Packaging on the tool says cannot return if opened... and I opened it. I have done this job 3 times and the second time on this washer. I smelled a rat when I found the bottom bearing press was very tight going into the inside diameter (ID) of the bottom bearing. I put the shaft in the freezer to help shrink it. I installed the bearings and the bottom press stuck inside the bottom bearing so I had to knock it out. Tried installing the new shaft and it won't go all the way thru the bottom bearing even with a 3lb hammer. So my kit did not contain the correct lower bearing to fit the shaft, but yes I opened the kit so I cannot return it. The "sealant" that comes thru is a generic package the says its the "original super glue". Kind of cheap and I would have used RTV if the shaft installed correctly. I went and purchased a new washing machine (old style) to remove this problem going forward. I opened the so I can't return it, my responsibility. Sorry, but I can't recommend this particular kit to anyone looking to do the same job.