Info
Alle Bewertungen (763)
- n***u (1026)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufThank you for accepting my offer. Brilliant transaction. Items brand new and exactly as described. Quick despatch and delivery. Absolutely no hesitation in using again or recommending this trader.
- bounding (20813)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufGood buyer, prompt payment, valued customer, highly recommended.
- m***d (60)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufGreat service and communication. Products as described. Would recommend and buy from again.
- popularcitynew (12638)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufQuick response and fast payment. Perfect! THANKS!!
- worldwidelectro (64459)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufQuick response and fast payment. Perfect! THANKS!!
- clearance101 (1873)- Bewertung vom Käufer.Letzte 6 MonateBestätigter KaufGood buyer, prompt payment, valued customer, highly recommended.
Rezensionen (2)

29. Mär 2017
Too thick and doesn't last
0 von 1 finden das hilfreich I needed this handlebar grip glue to stick down my new Oxford heated grips to my bike. The glue is very thick and when you slide the grip on it pushes most of the glue to one end, which means most of the grip is not stuck down. Sure enough my clutch side grip came loose after my first ride since installing the heated grips. I left the glue to dry for nearly a week. So I tried a second time, and it failed again. I cleaned up the handlebar on both occasions, and applied an even spread of glue.
The third time I restored to super glue, which sure enough is nice and thin and has held the grip down perfectly.
For some reason this glue worked perfectly on the throttle side, so it have a 50/50 failure/success rate.

22. Nov 2018
Much Better Than the OEM Plastic One
I'm pleased I replaced my plastic OEM bleed screw with this brass one. My old one was getting to the point where either it was going to crack (as plastic can do over time), or the top would break and I'd need a pair of pliers to get it off.
For only a few pounds you might as well swapping this over. I just wish there was a replacement one for the bottom of the radiator as well.