Info
Alle Bewertungen (269)
- linkall666 (18834)- Bewertung vom Käufer.Letzter MonatBestätigter KaufGood buyer, prompt payment, valued customer, highly recommended.
- salvagethrift (8435)- Bewertung vom Käufer.Letzte 6 MonateBestätigter KaufHope to deal with you again. Thank you.
- perfectdeal_us (234255)- Bewertung vom Käufer.Letzte 6 MonateBestätigter KaufHope to deal with you again. Thank you.
- goodfindings-7 (8562)- Bewertung vom Käufer.Letztes JahrBestätigter KaufHope to deal with you again. Thank you.
- esourceplus (185145)- Bewertung vom Käufer.Letztes JahrBestätigter KaufThank you for being a great buyer! A+
- easylink (388)- Bewertung vom Käufer.Letztes JahrBestätigter KaufExcellent buyer! Thank you for your purchase. Feel free to reach out if you have any questions.
Rezensionen (4)
16. Aug 2019
Needed parts were okay some parts not correct for Honda CB650SC
Roller bearings not correct and wouldn't fit shaft. Since 1983-1985 CB650SCs use same engine I am guessing that these wont fit any. The rubber parts fit correctly and the brush plate & brushes were an exact fit. I suspect the rear bushing is correct but mine didn't need it and it is a hassle to get the old one out so i didn't. I also needed to file my commutator down as it was not flat and probably contributed to the final wearing out of the old brushes. I may put a video up of rebuilding this starter as I did video the process and I could not find this starter sold as an assembly. With some work and 15 bucs I got my 35 year old starter crankin again, a pretty good deal!
07. Jul 2017
Easy to install on Samsung S7
I didn't use the software that came with it but just went to the Play store and found a CameraFi program and installed it. Camera came right up. The only part that didn't work too well was the 90degree mirror. With the LED lights running it reflected back into the camera. I think this is just what you get with these little cameras. I think there will be good uses for this. I used it to look inside the cylinder of a small engine. It came in a nice little metal case and had a attachable hook or magnet. Pretty good value
27. Aug 2017
If using with some LEDs it may need a small resistor.
1 von 1 finden das hilfreich Works well on my Honda Grom and has a good speed range of around 60 to 100 cycles per minute. I did end up putting a 1/4w 3k resistor across my front two LED turn signals because the front and back LEDs together did not pull enough current to run the flasher. They would just stay on at low brightness. Its a tiny resistor and anything between 1k and 3k worked fine and just wire it across the two LED wires(one for each side of the fronts). It doesn't pull enough to even warm the resistors.