Kontakt

Shop by category

    Info

    parts for two's and pews
    Standort: USAAngemeldet seit: 16. Apr 2012

    Alle Bewertungen (315)

    • mrcpartsplus (8474)- Bewertung vom Käufer.
      Letzter Monat
      Bestätigter Kauf
      Good buyer, prompt payment, valued customer, highly recommended.
    • dollarhobbyz_2 (292802)- Bewertung vom Käufer.
      Letzte 6 Monate
      Bestätigter Kauf
      Hope to deal with you again! Thank you!
    • actioninterestsrc (12914)- Bewertung vom Käufer.
      Letzte 6 Monate
      Bestätigter Kauf
      Good buyer, prompt payment, valued customer, highly recommended.
    • ocoroet (1340)- Bewertung vom Käufer.
      Letzte 6 Monate
      Bestätigter Kauf
      Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
    • horizonhobby (232122)- Bewertung vom Käufer.
      Letzte 6 Monate
      Bestätigter Kauf
      Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
    • f***f (298)- Bewertung vom Käufer.
      Vor über einem Jahr
      Bestätigter Kauf
      Great seller! Item arrived quickly and in excellent condition!
    Rezensionen (8)
    Remington 1100 1187 Magazine Spring fits 12 gauge - Part #F93188 NEW Made in USA
    18. Aug 2023
    Went in as needed, but not the same length as OEM
    It was shorter than the oem spring, but it also has a higher spring rate. Only got to check feed and fununction by cycling the action by hand, not firing the 1100. But again, note it is shorter and stiffer than the original.
    ARRMA ARA550112 dBoots Fortress MT Tire Set 12mm Hex 1/18 GRANITE GROM HH
    28. Jan 2025
    Granite grom back in action. Good oem pa...
    Granite grom back in action. Good oem parts for the truck.
    Ruger 90720 57 Optic Adapter Plate Black Burris/Vortex Fits Ruger 57
    17. Dez 2021
    Direct fit, no issues. Although it's aluminum.
    Fit fine, finish and quality is typical ruger. Only complaint is that the adapter is aluminum. That being said, do not go full on with the hardware, you WILL strip it. The fastener does have thread locking compound applied already. So just go to about 16 or 18in lb of torque. I don't have a wrench that goes that low. So i went snug, then another 1/4 turn. Mine may work lose over time. If so I'll take them out, and use red loctite and apply the same low torque. Better to do a job twice, than to have to buy any part twice. Side note, the factory vortex optic cover does not clear the rear sight with this base. It still goes over top of the red dot, but is not seated all the way. So it can come off very easily.

    Info

    Hier können Sie anderen eBay-Mitgliedern etwas über sich und Ihre Interessen mitteilen. Geben Sie Leuten mehr Gründe, Ihnen zu folgen!24/1000