coachnxs-2 auf eBay

Info

Standort: USAAngemeldet seit: 19. Apr 2012

Bewertungen

Letzte 12 Monate

Positiv3- positive Bewertungen der letzten 12 Monate

Neutral0- neutrale Bewertungen der letzten 12 Monate

Negativ0- negative Bewertungen der letzten 12 Monate

Alle Bewertungen (57)

blimpie50 (8330)- Bewertung vom Käufer.
Vor über einem Jahr
Bestätigter Kauf
Fast payment. A great Ebay buyer!
rtmerc8 (1737)- Bewertung vom Käufer.
Letzte 6 Monate
Bestätigter Kauf
Good buyer, prompt payment, valued customer, highly recommended.
tncrash874 (2130)- Bewertung vom Käufer.
Letztes Jahr
Bestätigter Kauf
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
itswhatyouneed (1038)- Bewertung vom Käufer.
Letztes Jahr
Bestätigter Kauf
Great Buyer! Quick Payment!! A+++++
geeklove321 (886)- Bewertung vom Käufer.
Letztes Jahr
Bestätigter Kauf
PERFECT - ▄▀▄▀▄▀▄▀▄▀▄▀█▓▒░T░H░A░N░K░ ░Y░O░U░▒▓█▀▄▀▄▀▄▀▄▀▄▀▄
powercallsirens (8472)- Bewertung vom Käufer.
Vor über einem Jahr
Bestätigter Kauf
Great transaction, thank for your business!

Alle Bewertungen ansehen

Rezensionen (4)

NOS FORD MERCURY LINCOLN OIL PRESSURE SENDER CONTINENTAL MONTEREY FAIRLANE 1956

25. Mai 2021

Glad that parts for my old car are still available from sourc4s that care about restorations.

NOS oil pressure sender bench tested ok; will be a while before I actually install it but I don't expect any problem.

New 1954-62 272 292 312 Ford T-Bird Y Block Spark Plug Wire Set & Bracket Kit

12. Feb 2020

Most like originals and a good buy

This set of spark plug wires is very well made, already cut to length for original type routing, and properly numbered. Only needed some boot grease to complete the installation. The boots are as the originals, being straight on the cap end and 90 degrees on the plug end. Plug wires are black and the coil wire is brown like originals. Excellent crimps on stranded wire. These are not "resistor" wires which is what I wanted. Might need a high frequency filter for the radio but that's ok with me. Wires also have abrasion sleeves where they come near metal engine parts.

Graphite Blank Block Sheet Plate High Density Fine Grain 3/8" x 2" x 12"

22. Jun 2021

Much better choice for anodes in the electrolysis process !

I have used the electrolysis process for years to remove rust and paint from parts. The sacrificial anode that I would use was old sheet metal that quickly became coated with debris and had to be cleaned in order to reuse. This was messy and time consuming. These bars of graphite 2" x 12" x 3/8" perform well and eliminate the problem of deteriorating anodes. along with the mess. I learned about them on a you tube video and was glad to have found them and I highly recommend them for use in the electrolysis process.

Alle Rezensionen ansehen