Info
Alle Bewertungen (267)
- brandchemicals (32208)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufGreat buyer. A pleasure to do business with.
- mplay_sale (15332)- Bewertung vom Käufer.Letzter MonatBestätigter KaufWonderful buyer! Thank you so much for your purchase, and I hope you enjoy your item!
- wheatleyukltd (11984)- Bewertung vom Käufer.Letzter MonatBestätigter KaufA pleasure to do business with please use gardentoolbase again
- loveourprices2 (120336)- Bewertung vom Käufer.Letzte 6 MonateBestätigter KaufGreat communication. A pleasure to do business with.
- worldofbooks08 (10440592)- Bewertung vom Käufer.Letzte 6 MonateBestätigter KaufGreat communication. A pleasure to do business with.
- uniteleve22 (814)- Bewertung vom Käufer.Letzte 6 MonateBestätigter KaufThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
Rezensionen (14)
03. Apr 2018
Comparing prices with other toolposts plus tool carriers it's very good value
The overall build is good. However it would have helped to have a more complete description. In particular, since I had to modify the mounting on my Harrison 140, a diagrammatic section through the toolpost showing the dimensions would have been very useful. In the end I managed, but I would have liked to have been sure, especially when the item is advertised specifically as being suitable for my machine. However, this is a matter of advertising and does not detract from the quality of the toolpost in general.
15. Jan 2019
Cut your own for any oven
I wanted this as a cheap replacement for the DeDietrich rip-off. It was a tenth of the price and I can cut two DeDietrich-size windows out of it. And it's very easy to cut. Excellent.
01. Jan 2019
Not quite what I wanted, but its quality makes up for that.
1 von 1 finden das hilfreich I wanted this drive to power the cross-slide of a lathe. For this it has to rotate very slowly, so I use the lowest speed of the drill (which is large, so there is plenty of power to deliver torque) and have a 4:1 speed reducer in the drill chuck.
The results, in terms of the quality of the turned surface produced in the lathe, are quite good, but I had to be careful to keep the drive shaft straight since a slight amount of off-centre allowed the shaft to flex and store elastic energy, leading to slightly uneven rate of advance of the slide.
The standard of construction is good; I suspect I am trying to use the drive at its limit. A shorter drive cable (a tenth of the length - 100mm) would eliminate this problem but I couldn't find such a short cable listed.