Info
Alle Bewertungen (49)
- onlineonlimestone (16576)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufGreat communication. A pleasure to do business with.
- charityoutlets- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufHope to deal with you again. Thank you.
- kastarusa1 (255546)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufThank you very much for your order!
- crazyshopaholic-1107 (10478)- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufHope to deal with you again. Thank you.
Rezensionen (4)
12. Jan 2018
Working Well So Far
I've used this to connect an older computer with a VGA output to a new monitor with HDMI input. It has worked without any problems for around 8 months now.
17. Mai 2018
Better than the Original--Probably
1 von 1 finden das hilfreich I used this part to replace a broken coupling on a Kenmore 110.24632300 washer.
I can't say that I know that this part is of good quality, but it appears to be less likely to break than the original plastic version due to the metal insert. My replacement part has only been in service for a few weeks now.
Note that the coupling doesn't install without some force because the metal inserts are undersized a bit relative to the motor shaft and transmission shaft to which the two halves of the coupling attach. I used a socket and hammer to force the coupling onto the shafts. (Use a backup board at the other end of the motor shaft to avoid damage to the motor bearings.) If the coupling halves have been pushed onto the shafts far enough, the spring clips that hold the motor in place should snap into place without much trouble. Otherwise, they can be difficult to install. Don't force the clips into place instead of readjusting the couplings because this generates force on the motor's internal moving parts (bearings presumably), which generates extra friction and thus heat. (This caused a burning smell in my case, which was eliminated after pushing the coupling halves further onto the shafts.)
12. Jan 2018
DeWalt Drill Battery Pack Rebuilding
I used these to replace defunct batteries in two DeWalt drill battery packs. The tabs are long enough to avoid the need for wire to make connections.I soldered the tabs together.