Info
Alle Bewertungen (840)
big-saving-usa (51084)- Bewertung vom Käufer.
Letzter Monat
Bestätigter Kauf
Good buyer
janyamga-11 (31)- Bewertung vom Käufer.
Letzter Monat
Bestätigter Kauf
Great communication. A pleasure to do business with.
tyllq (117594)- Bewertung vom Käufer.
Letzter Monat
Bestätigter Kauf
Great communication. A pleasure to do business with.
qualitysellerssince1998 (4905)- Bewertung vom Käufer.
Letzter Monat
Bestätigter Kauf
Hope to deal with you again. Thank you.
s9cb_radios (5115)- Bewertung vom Käufer.
Letzte 6 Monate
Bestätigter Kauf
Big Thanks From Classic Electronics!!!!!!!+++++++++++
usaonlinedirect (29050)- Bewertung vom Käufer.
Letzte 6 Monate
Bestätigter Kauf
Good buyer, prompt payment, valued customer, highly recommended.
Rezensionen (6)
13. Apr 2018
These headphones are excellent to mod!
These headphones are made out of the chewy McDonald's toy plastic. it won't shatter or crack if mishandled. Secondly they have standard sized 40mm drivers in them. if you have a pair of headphones laying around that sounded great till they broke in half, take the speakers out of them and put them in these! it takes a small amount of DIY know how and some hot glue/solder work but I guarantee you will be able to make a set of high quality bomb proof headphones that will last just about forever out of these. Best of all they won't get stolen! I was able to mod these into some headphones that hit harder than Beats. It's a fun weekend project that doesn't cost that much to up cycle!
05. Dez 2017
It's pretty decent for a cheap stand
I have two of these stands for my microphones. they do an adequate job of holding my mics up and out of the way. These stands I wouldn't recommend for a professional but are sturdy enough for home use. They may not hold heavy professional condenser microphones but will hold an old Radioshack Hi-Ball just fine. They also work fine with the Newer Condenser Microphones. I would not recommend moving the mic placement a whole lot as the stand may not be able to handle rough use.
22. Jun 2018
This will indeed make your mower run again so long as you have a clean gas tank, compression, and spark
I like this because it's easier and much cleaner than messing with an old carb. However even though it is an exact fit for my mower, the fuel mixture is too much and it runs too fast. if you can salvage the original jet bolt from the bottom, use that instead. just make sure you use a wire from a steel brush to clean the tiny passages. The easiest way to install the carb is to remove the exhaust if the intake is below the exhaust. if you have an older engine it's much easier to change out.