Patience Using Super Glue a MUST!
If you have never used supper glue of any brand, it can be tricky.
The bottle of Gorilla glue I bought, was only half full. This posed a problem.
The hole in the nozzle must be breached, typically will a paperclip. Once air enters the nozzle, glue residue inside the nozzle immediately hardens. So, you have to again, poke a hole in the nozzle. This is frustrating.
It is important that when you shake the bottle before use, you make sure the glue is near the nozzle. Otherwise, the glue will not come out. Again, you will have to re-poke the nozzle hole.
More frustration!
Once you manage to get Gorilla glue on one of the surfaces you wish to bond, pressing the two items together for 10-45 seconds, isn't long enough. In my case, I held the two surfaces together for 3 minutes. The glue finally set enough, allowing me to let go.
As per the bottle instructions, you should wait 24 hours for the Gorilla glue bonding process to be complete, before attempting to test the bonded items to make sure they are firmly stuck together.
Good luck to you with your Gorilla glue-bonding project. May you be less frustrated than I was.
Kind regards
Bestätigter Kauf: JaArtikelzustand: Neu