MOMENTAN AUSVERKAUFT
Über dieses Produkt
Product Identifiers
BrandArduino
MPNDHT22
eBay Product ID (ePID)1643252710
Bewertungen und Rezensionen
Relevanteste Rezensionen
- 10. Nov. 2017
Bought 2 units
Unfortunately neither of the two units work. At first 1x was tried on Raspberry Pi Model 3B and although it appeared to communicate, temperature always reported 0 and humidity 0.1% so tried again on Arduino but always an error. Since not working I then took the sensor off the PCB to wire directly from the sensor with exactly the same results. Shame but if they don't work then I can't give a more positive review - sorry.Bestätigter Kauf: JaArtikelzustand: Neu
- 28. Dez. 2017
Disappointing design
The pins are not a standard width (i.e. dupont/breaker) so cannot be easily attached to anything without soldering some dupont pins on and these version are missing a 10k ohm pull-down resistor between the voltage and data pin, and provide widely inaccurate readings without the resistor (which begs the question, why don't these sensors have them on board)...well it turns out there are versions of this sensor with the proper pins and the resistor build in (see pic) - I wish I had bought those instead, as this is version is a pain to work with.
Bestätigter Kauf: JaArtikelzustand: Neu
- 30. Nov. 2017
It
Bestätigter Kauf: JaArtikelzustand: Neu
- 25. Mai. 2016
Good
Working good with not a big error and fast response 5sBestätigter Kauf: JaArtikelzustand: Neu
