Bewertungen und Rezensionen

Mehr erfahren

4.9

124 Produktbewertungen

114 Nutzer haben dieses Produkt mit 5 von 5 Sternen bewertet
5 Nutzer haben dieses Produkt mit 4 von 5 Sternen bewertet
3 Nutzer haben dieses Produkt mit 3 von 5 Sternen bewertet
1 Nutzer haben dieses Produkt mit 2 von 5 Sternen bewertet
1 Nutzer haben dieses Produkt mit 1 von 5 Sternen bewertet

Good value

Would recommend

Good quality

Relevanteste Rezensionen

Alle 96 Rezensionen sehen

von tailgunner91
17. Mai. 2016
Looks identical to old one
Definitely what my Beckett burner boiler needed. My only gripe is the label - must be made in china, since all the lettering washed right off after cleaning up residual oil with brake cleaner. Better take a picture of this picture if you want to service it in the future. My old one was 20 years old, and the internal check spring very weak, causing afterburner and drip. With this new one, I can hear the flame go out before the burner even finishes spooling down. Time will tell if this one is as robust as the original.
Bestätigter Kauf: JaArtikelzustand: Neu
von smitrovic1982
17. Mai. 2016
good oil pump
Replaced a 20+ year old Suntec A2VA-7116 burner oil pump that had problems adjusting pressure with this new one. I also had to adjust the pressure on it from 100 psi to burner default 140 psi and so I used a pressure gauge that was part of a pump testing manifold develped by Mitco where one can check both the pump pressure and vacuum readings. After some smoke level and draft adjustments my oil burner runs without any problems so far.
Bestätigter Kauf: JaArtikelzustand: Neu
von whipmixmechanic
15. Feb. 2017
Perfect fit and instant start.
Perfect fit made for an easy install. Ports are clearly marked so there will be no confusion which line goes where. Burner fired after only about a two second line bleed. If your fuel line fittings are in good enough condition for re-use, you will not need anything else except for perhaps some fuel-compatible thread sealer. All that said, installation by a professional licensed technician is recommended and in most cases required by local codes. This unit is NOT compatible with fuel blends with higher than 5% biodiesel content.
Bestätigter Kauf: JaArtikelzustand: Neu
von pedon-holl
11. Dez. 2018
Exact replacement for a great price!
Exact replacement for Mother in law's furnace. Her furnace broke in beginning of winter, was very cold (freezing), a snow storm was coming and she couldn't afford a new furnace. My hubby ordered this, replaced it and by the grace of God, it worked! His 70 yr old Mom had heat!!
Bestätigter Kauf: JaArtikelzustand: Neu
von 67tygh
19. Aug. 2016
Works right, no leaks.
With the cost of verifying environmental compliance I wanted a new pump that would give consistent performance for a very long time. I saved the old pump as a backup spare part.
Bestätigter Kauf: JaArtikelzustand: Neu
von doubled_1948
26. Dez. 2017
Great value and easy to understand instructions for replacing...but
The only complaint...it took an air wrench to remove the inlet and bypass bolts. They were definitely tightened too much at the factory. I know you don't wan't them coming loose if they're the ones you need to leave in....but this was ridiculous.
Bestätigter Kauf: JaArtikelzustand: Neu
von vultch120
15. Dez. 2020
Worked great !! Fast shipper
After looking at several listings, I chose this one because it is new, not refurbed. It was packed well and had factory lube in it. Also had sealed instructions and a plug if needed. After draining the factory oil (which is not fuel oil) and installing on a Beckett burner, it primed very quickly and worked flawlessly. Very pleased with the outcome.
Bestätigter Kauf: JaArtikelzustand: Neu
von rH0RA5nXSvi@Deleted
23. Mär. 2019
Pump for my Oil fired heater
I needed a pump for my oil fired heater checked around my local stores they wanted $94 for a standard pump these guys had it for $63 with the coupling kit I received it a day early if you need anything for your heater buy it here you won’t get it anywhere else any cheaper
Bestätigter Kauf: JaArtikelzustand: Gebraucht
von ragtop
24. Aug. 2021
af2 oil burner pump
I bought as a spare., it is identical to the original OEM pump we live in a rural area and i take care of my own system it is both our hot water and in floor heat so i keep spare parts for everything
Bestätigter Kauf: JaArtikelzustand: Neu
von andhama_0
06. Mai. 2020
Awesome and fantastic
It was a great ! The arrival day was ahead of the stated day . The price was the right fit for my budget. And it came right in a good time thank you! And whenI install it no need to prime . Fantastic !
Bestätigter Kauf: JaArtikelzustand: Gebraucht