MOMENTAN AUSVERKAUFT
Über dieses Produkt
Product Identifiers
BrandCustom Dynamics
Manufacturer Part NumberGEN2-SSUNV
eBay Product ID (ePID)220650008
Additional Product Features
Part TypeModule Signal Stabilizer
Bewertungen und Rezensionen
Relevanteste Rezensionen
- 27. Feb. 2018
nice compact size
Like all "cd" products Iv'e used. Once again over the top in fit & quality. In my case even the wiring colors matched my harness. That says a lot to me. Instructions were in color and very easy to understand. Hardest part was figuring out where to mount it. Its small enough to put in several places out of sight.Bestätigter Kauf: JaArtikelzustand: Neu
- 02. Mär. 2017
An excellent alternative to load equalizer resistors
Changing over to four LEDs (1992 BMW R100R) resulted in a fast flash-rate. I had some load resistors lying around so tried at first two resistors (one per side), which didn't help. So, went with four (one per light). That did the trick but significantly complicated an otherwise simple wiring setup, and all the extra wiring joints meant many more points for potential failure. Plus, each resistor gets really hot and four of them get hard to hide on a minimalist naked bike. The Custom Dynamics unit is really straightforward to install (like literally five minutes using the included) positaps, and could be hidden completely inside my frame's top-tube. Best of all, it produces no heat. Quality-wise, the case is tough plastic and the electronics are completely sealed on the back side with poured epoxy. the wires are good quality and protrude through the epoxy. The only potential point of water-ingress appears to be a tiny slide-switch on one end. After choosing the best (of the two positions) for setting the flash-rate, I put a little piece of duct-tape over the switch, just to be sure no water or crud would get in there. Very happy with the unit and can highly recommend if you have LED-related flash-rate problems and can't just use a modern non-load dependent flasher unit (the BMW's flasher unit also controls several other things, so can't easily be swapped out).Bestätigter Kauf: JaArtikelzustand: Neu
- 23. Jan. 2021
Easy install, no more hyper flash or engine codes
The unit is very easy to install. I installed it on the front turn harness as it's easier to access on a V-Rod. Wire colors from the factory harness are the same as the unit. The Posi-taps are easy to install and remove, should you need to. Got rid of the hyper flashing(which wasn't a huge issue for me) and more importantly, the engine code it was throwing for the TSS is gone. Not a cheap unit but you get what you pay for. No heat coming off this unit at all.Bestätigter Kauf: JaArtikelzustand: Neu
- 10. Mär. 2021
Love it
It done exactly what I needed it to do. Very happy and pleasedBestätigter Kauf: JaArtikelzustand: Neu
