sedated_penguine96ir auf eBay

Info

Standort: USAAngemeldet seit: 18. Jul 2000

Bewertungen

Letzte 12 Monate

Positiv4- positive Bewertungen der letzten 12 Monate

Neutral0- neutrale Bewertungen der letzten 12 Monate

Negativ0- negative Bewertungen der letzten 12 Monate

Alle Bewertungen (137)

matmur-63 (3738)- Bewertung vom Käufer.
Letzter Monat
Bestätigter Kauf
Good buyer, prompt payment, valued customer, highly recommended.
sunnyw_36 (10530)- Bewertung vom Käufer.
Letzter Monat
Bestätigter Kauf
Quick response and fast payment. Perfect! THANKS!!
my.smart.store (1147)- Bewertung vom Käufer.
Letzter Monat
Bestätigter Kauf
Quick response and fast payment. Perfect! THANKS!!
zshengracingparts (1331)- Bewertung vom Käufer.
Letztes Jahr
Bestätigter Kauf
Hope to deal with you again. Thank you.
reliableaftermarketpartsinc (664674)- Bewertung vom Käufer.
Vor über einem Jahr
Bestätigter Kauf
Reliable Aftermarket Parts Highly Recommended Buyer+++
simpletire (263364)- Bewertung vom Käufer.
Vor über einem Jahr
Bestätigter Kauf
▀▄▀▄▀▄█▓▒░ Outstanding buyer, Quick Payment! A++ ░▒▓█▀▄▀▄▀▄▀▄

Alle Bewertungen ansehen

Rezensionen (2)

Louisiana Grills Wood Pellets 40 lb. Georgia Pecan BBQ Tools Accessories Outdoor

02. Dez 2017

Confusing packaging

Package looks different from pictured almost gave a bad review until I finally found out it was pecan in a small tag

Omix Valve Cover New J Series Jeep Cherokee CJ7 CJ5 Scrambler J10 17401.08

18. Aug 2017

Good but could use small improvements

When I installed this part I followed all directions to the best of my ability (will explain) I removed the plastic junk stock one and set this one on there to make sure bolt holes lined up from what I could see everything lined up good (the one in the back next to the firewall was not visible) which ended up being a problem especially because I was using the stock bolts there is some chance if I had used the new allen heads supplied it might have fit better but I doubt it all that said I did eventually get it to fit but it took hours and when I drilled the inside holes out (intake side) so I could tap them to take the new bolts according to the direction I barely got down to where the hole needed to be and I hit the water jacket same on both bolts so I wrapped them up with teflon tape and tried to flush out the system as best as possible no leaks so far just didn't seem right

Alle Rezensionen ansehen