Info
Alle Bewertungen (101)
- nourishcottage (23717)- Bewertung vom Käufer.Letzter MonatBestätigter KaufThank you for shopping with us! Hope to see you again!
- *****- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufGreat communication. A pleasure to do business with.
- *****- Bewertung vom Käufer.Letzte 6 MonateBestätigter KaufThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
- outlawperformanceexhaust (638)- Bewertung vom Käufer.Letzte 6 MonateBestätigter KaufGreat communication. A pleasure to do business with.
- riverstone88 (62178)- Bewertung vom Käufer.Letzte 6 MonateBestätigter KaufHope to deal with you again. Thank you.
- l7fsc5f-tiw@Deleted- Bewertung vom Käufer.Vor über einem JahrBestätigter KaufQuick response and fast payment. Perfect! THANKS!!
Rezensionen (3)
23. Mai 2019
It's an OK product and will work
I have not actually fitted it yet but will keep it as a backup and I fully expect it will work when I need it. It appears to be of good solid build and the correct size to bolt straight into the original mounts. Price and turnaround time was very good. The primary coil resistance measures on an Ohm meter correctly for the Holden 202 HEI, which is the main thing electrically. The secondary coil should measure 8000 ohms (Commodore VH Gregory Workshop Manual is my source) but it only measures 5500 ohms. I'm sure the coil will still create a spark but likely not as "fat" a spark as it might have, due to the reduced ratio of coil turns.
14. Nov 2018
Prop shaft nut tool for old landies and new!
My nuts were properly stuck on my old 109 series 3. None of my sockets had a thin enough wall thickness to get fully on the nut without burring it. The spaces are really tight and the new tool did the trick for the most part. I still had to angle grind off a couple off nuts. If the wall thickness was just a little less i might not have needed to do that but then the tool may not have been as strong in that case. Overall the tool made the job much easier than my past experiences doing this job. Cheers :-)
20. Mai 2021
Good fit for 1971 2A
Have not fitted them yet, only offered them up and tested the threads in the wheel cylinders which are out for rebuilding. Still a way to go but these look right and have the right ends and lengths for my Series 2A 1971