Features:

1. 100 levels of vibration.
2. 100 levels of static (optional).
3. The levels can be altered by use of up & down button.
4. A tone button activates a tone on the receiver.
5. The system can be used 2 receivers
6. The receiver will TURN OFF if it is unused for 4 minutes.
7. Any movement will activate the receiver into STANDBY MODE.
8. The transmitter will go into STANDBY MODE if there is no operation after 20 seconds and turn off after 2 minute.
9. Adjustable belt length, maximum diameter of 18cm, two pairs of metal prongs to suit dogs with varied fur thickness.

For 2 pairs of collar, please click here: " 2 Pairs E-Collar "

Specification :

Collar:
Length: 43mm Height: 68mm Width: 38mm
Weight 56g (module + battery)
Collar length adjustable from 12 inches to 20 inches
Power:2 x 1.5V AAA battery (included)
Water Resistant and shockproof
Handset:
Length: 83mm Height: 25mm Width: 45mm
Weight: 40g (with battery)
Power: 2 X 4LR44 6V batteries (included)
LED signal light and illumination at night
The sound function for attracting attention

Package Including:

1 x Remote transmitter
1 x Collar
1 x Test Light
2 x AAA Batteries
2 x 4LR44 6v batteries
1 x User manual

Matching Receiver and Transmitter:

1. Turn on the transmitter by the switch on right side of it
2. Install the batteries for the receiver. The LED inside the receiver starts to keep flashing. Press vibration or shock button immediately after batteries are put into the receiver firmly. Then the LED will stop flashing and only light which indicates that the transmitter and the receiver have matched each other successfully.
3. If LED stops flashing on its own without press any button in the transmitter, take out the batteries. Wait for at least 10 Seconds and try step 2 again.
4. Put the cover on the receiver firmly
5. Attach the receiver to the collar.